PDA

View Full Version : epson equity 1



man486er
February 27th, 2005, 10:42 AM
HOW CAN I GET INTO THE SETUP ON THIS 386!?

I TRIED WHAT I KNOW.IT TELLS ME TO RUN SETUP FROM
DIGNOSTICS,THAT IS ALL GOOD AND WELL.
BUT TO RUN THIS I NEED ACESS TO THE FLOPPY..

ANY IDEAS??
:?:

Terry Yager
February 27th, 2005, 11:37 AM
For starters, the Equity I ain't a '386, it's an 8088, therefore, there is no setup in CMOS RAM. Setup is accomplished by setting the DIP switches located behind the door on the front panel, below the disk drive(s).
Secondly, Epson is pretty good about providing support for it's legacy products, you should always check thier website first.
Thirdly, d/l the user's manual here:

http://www.epson.com/

Select: USA> Drivers & Support> Desktop Computers> Equity I> Documents & Manuals

--T

P.S. I hope you didn't get burned, thinking you were buying a '386 'pute.