Image Map Image Map
  • Category Widget (bottom-up)

  • PeterNY

    There is no available content written by PeterNY
  • Recent Article Comments Widget

  • Recent Forum Posts

    the3dfxdude

    I guess you haven't tried setting up a new email...

    I guess you haven't tried setting up a new email domain today. You can go through and do all the proper settings for DNS and email server, on a fresh domain. You can check all the blacklists to make...

    the3dfxdude Today, 08:31 AM Go to last post
    Dwight Elvey

    The STM32 parts will have similar issues if you...

    The STM32 parts will have similar issues if you use the internal pull-ups. You should have them as floating inputs and open drain only for the 5V tolerant I/O. This is documented in the specs. If you...

    Dwight Elvey Today, 08:28 AM Go to last post
    glitch

    You have probably destroyed the DS1287, most ICs...

    You have probably destroyed the DS1287, most ICs won't survive being installed backwards. Probably not the motherboard though, since there's only 5V logic on the DS1287. You will have to buy a...

    glitch Today, 08:18 AM Go to last post
    romanon

    Seagate ST-4053 and IBM AT

    Hello, I tried connect my ST-4053 to IBM AT (type 3 board).
    First problem - ok this disk is not supported by IBM BIOS, its 1024/5/17 and this CHS parameters are not compatible with any type of...

    romanon Today, 08:12 AM Go to last post
    Chuck(G)

    You're not following. If the logic level from...

    You're not following. If the logic level from the drive is higher than the supply voltage to the PSoC, the datasheet says that you're going to have problems.

    This is not the case with...

    Chuck(G) Today, 08:04 AM Go to last post