On a hunch using a wire I connected pin 15 (LOAD_DAR_H) of the 50 pin header (J4) on the SBC6120 directly to the 74ACT373 latch-enable pin while leaving the 1k pull down in place.
The GAL firmware sources and JED files are different as compared to what is on their websites. It seems I cannot attach a ZIP file, so if you PM me with your email address, then I can send the latest...
Category Widget (bottom-up)
Recent Article Comments Widget
Recent Forum Posts
Success! On a hunch using a wire I connected...
Success!
thunter0512 Today, 01:03 AMOn a hunch using a wire I connected pin 15 (LOAD_DAR_H) of the 50 pin header (J4) on the SBC6120 directly to the 74ACT373 latch-enable pin while leaving the 1k pull down in place.
It...