Image Map Image Map
  • Category Widget (bottom-up)

  • Recent Articles

  • smp

    There is no available content written by smp
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    xjas

    Packing desktop/minitower systems for shipping

    I have a few beige boxes (386~P2) that need to find a good home ASAP. The local market for this stuff is nonexistent, so I'll probably end up using Ebay.

    I've been putting it off because I REALLY...

    xjas Today, 12:10 PM Go to last post
    Marty

    Hi All; Dave, Thank You for the Reply.. ""...

    Hi All;

    Dave, Thank You for the Reply..

    "" There are copper pads for attaching +5V, 0V/GND, +12V and -5V to the board. ""

    Yes, I saw them, I wasn't sure if I should solder any wire to...

    Marty Today, 12:09 PM Go to last post
    MauriceH

    Have the setting correct? Use local echo (turn...

    Have the setting correct?
    Use local echo (turn it on in the setup menu)
    so you can visualy see if the keybord is working on the screen.

    Then check all the setup communications.
    Compair with...

    MauriceH Today, 11:54 AM Go to last post
    Svenska

    The PSU uses a higher voltage than the battery,...

    The PSU uses a higher voltage than the battery, so using the PSU on the battery connector will destroy the machine. Using a correct voltage PSU should work, but I never tried it on a Toshiba (I did...

    Svenska Today, 11:49 AM Go to last post
    daver2

    It's your board - you do with it what you want......

    It's your board - you do with it what you want... That is the great idea of this thing!

    There are copper pads for attaching +5V, 0V/GND, +12V and -5V to the board. They are located on the...

    daver2 Today, 11:44 AM Go to last post