Image Map Image Map
  • Category Widget (bottom-up)

  • classiccomputing

    There is no available content written by classiccomputing
  • Recent Article Comments Widget

  • Recent Forum Posts

    Hugo Holden

    I have used Copperset for many years to restore...

    I have used Copperset for many years to restore plated through holes.

    These are fine sleeves filled with solder, you fit them to a hole, and use a small punch to expand them, de-solder the hole...

    Hugo Holden Today, 03:03 AM Go to last post
    daver2

    Commodore 8032 repair.

    Finally started repairing my 8032 with an 8032030 80 column main board.

    Electrical safety checks - OK.

    Transformer AC supply checks - OK.

    DC supply checks (black smoke time) - OK.

    Reset...

    daver2 Today, 02:59 AM Go to last post
    Hugo Holden

    The fact is without the schematic these supplies...

    The fact is without the schematic these supplies can be awkward to repair.

    I faced exactly the same issue with a 5155 supply, no manual. But if you are determined you can do what I did and copy...

    Hugo Holden Today, 02:39 AM Go to last post
    onre

    Around here I'd guess 20-30 € for blasting and...

    Around here I'd guess 20-30 € for blasting and powder coating for a simple part like that. I got a bicycle frame + fork done for 50 € and that was already somewhat labor-intensive with all the...

    onre Today, 02:20 AM Go to last post
    Malc

    Yup find a professional paint shop that does...

    Yup find a professional paint shop that does Powder coating, I don't know about being cheap though, I've never had one done, I've scrapped loads of cases over the years because of rust, The question...

    Malc Today, 02:10 AM Go to last post