During the 5160's POST, the POST changes the output state of the PB7 pin a few times. The final state is LOW.
The second drive-select position: DS2 if the the drive's jumpers are {DS1}{DS2}{DS3}{DS4}. DS1 if the the drive's jumpers are {DS0}{DS1}{DS2}{DS3}. And per the diagram at [here], the motor-on...
No, I just like to show off my high-falutin' chemistry. :) Tetrachloroethylene = "Perc" = dry cleaning fluid. At least it does today--who knows what the EPA will do tomorrow.
Correct. "NO KEYBOARD" does not appear. And I confirmed it again, today. What I do is put my multimeter into continuity mode (i.e. beep at low ohms), put one probe on the reference pin, then...
Wondering if there's an issue with a US 240V PDU on Euro mains. US 240V (and 208V) single-phase assumes that both legs are "hot" with respect to ground and uses a 2-pole circuit breaker. Euro...
Category Widget (bottom-up)
Recent Article Comments Widget
Recent Forum Posts
During the 5160's POST, the POST changes the...
During the 5160's POST, the POST changes the output state of the PB7 pin a few times. The final state is LOW.
modem7 Today, 07:16 PM