I had given up on any hopes to get it to work again at that point, so I just removed them to see where the bumper stop was.
In all honesty I didn't think of it at first when I removed them, as I...
Looks like I have already grabbed that. The 11/04 has been sitting there ever since I got it because I was told it had an intractable PSU issue, but I plan to take a look at it soon.
I looked at the refresh signals on the address muxes tonight. On the muxes themselves I connected the logic analyzer to the 7 refresh bits, the two mux control bits, and the 7 output bits for the...
Re: soldering iron. Depends on the type and application; 40W is typical. Whatever, get a temperature-controlled unit. You can do a lot of damage to a PCB with an uncontrolled iron.
Category Widget (bottom-up)
Recent Article Comments Widget
Recent Forum Posts
I had given up on any hopes to get it to work...
I had given up on any hopes to get it to work again at that point, so I just removed them to see where the bumper stop was.
RetroSpector78 Today, 12:19 AMIn all honesty I didn't think of it at first when I removed them, as I...