Image Map Image Map
  • Category Widget (bottom-up)

  • Recent Articles

  • paul

    There is no available content written by paul
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    Malc

    I assume you mean the Lo-Tech ISA - CF rev3 or do...

    I assume you mean the Lo-Tech ISA - CF rev3 or do you mean the GW XTIDE Rev 3 ?, What version of the XUB are you using, Did you configure it properly using XTIDECFG.com first before flashing to...

    Malc Today, 12:17 AM Go to last post
    Hugo Holden

    If you had text data coming out of the vid pin of...

    If you had text data coming out of the vid pin of U21 before you replaced the 74ls08 (was that the case ?) then it disappeared after it was replaced, likely something did happen to the pcb...

    Hugo Holden Yesterday, 11:57 PM Go to last post
    MattisLind

    Need some assistance on how to best...

    Need some assistance on how to best troubleshooting why I cannot get my two XT-IDE rev 3 boards working. I bought bare boards and populated them myself using ICs from my parts drawer which mostly...

    MattisLind Yesterday, 11:56 PM Go to last post
    super-sama

    yep so doing more digging, per this tidbit here,...

    yep so doing more digging, per this tidbit here, for the WD76C30 super IO chip onboard...
    "Integrated clock generation circuitry uses the 48 MHz input signal to generate the 1.8462, 3.072, and 8.0...

    super-sama Yesterday, 11:41 PM Go to last post
    falter

    Thanks Hugo. Before attempting my repair I...

    Thanks Hugo.

    Before attempting my repair I saw signals at pins 12 and 13 on the 74ls08, and nothing on pin 11. I verified it a few times.

    So I removed it and subbed in with another, hoping...

    falter Yesterday, 10:24 PM Go to last post