Image Map Image Map
  • Category Widget (bottom-up)

  • AkBKukU

    There is no available content written by AkBKukU
  • Recent Article Comments Widget

  • Recent Forum Posts

    iz8dwf

    The top head of a 1571 is lifted by only one side...

    The top head of a 1571 is lifted by only one side support. This causes after many years a little twist in the head orientation and it's not sitting flat against the disk surface anymore, plus isn't...

    iz8dwf Today, 12:20 AM Go to last post
    falter

    One other thing I've noticed.. in pictures of...

    One other thing I've noticed.. in pictures of other Mindsets I see the power supply fan plugged into the center of the motherboard. On both of mine.. it is plugged into J13, right next to the PSU. ...

    falter Today, 12:03 AM Go to last post
    falter

    No.. I think I have almost every Commodore...

    No.. I think I have almost every Commodore monitor except that. I have only two vintage PC compatible monitors.. my 5151 and the 5154.

    Thing is.. the composite shouldn't require anything funky,...

    falter Yesterday, 11:38 PM Go to last post
    Jan1980

    I loaded this zmac assembler ! That is exactly i...

    I loaded this zmac assembler ! That is exactly i was looking for ! Great ! I wrote a new Bios, i assembled the distribution CP/M code, i learned to work with macros library and now, i am not able to...

    Jan1980 Yesterday, 11:17 PM Go to last post
    blackepyon

    I'd say about 2-3x as much. This is fine if...

    I'd say about 2-3x as much. This is fine if you're card doesn't have a back panel mounting bracket, and the socket is all that's holding it in place. Then it's not going anywhere.

    But you need to...

    blackepyon Yesterday, 10:57 PM Go to last post