Image Map Image Map
  • Category Widget (bottom-up)

  • iz8dwf

    There is no available content written by iz8dwf
  • Recent Article Comments Widget

  • Recent Forum Posts

    ldkraemer

    MCM Electronics used to have a good listing for...

    MCM Electronics used to have a good listing for BELTS in their catalog. But, I understand that they have been
    bought out by someone, and I don't know who. If they still have a website you might...

    ldkraemer Today, 05:16 PM Go to last post
    ldkraemer

    Chuck's suggestion is GOOD. One problem I have...

    Chuck's suggestion is GOOD. One problem I have seen with the Commodore C-64 is, the traces are so thin
    that it's impossible to scrape them and add solder, then the wire. For traces that thin, I go...

    ldkraemer Today, 05:09 PM Go to last post
    rittwage

    Sorry guys, I was out of town for a week for a...

    Sorry guys, I was out of town for a week for a death in the family. I replied to Jim, but I replied to the e-mail notification which never got to him. I have replied to the PM now and a few others.
    ...

    rittwage Today, 05:06 PM Go to last post
    Chuck(G)

    That's pretty much the idea.. Clean the mask off...

    That's pretty much the idea.. Clean the mask off of each end of the break, tin the bare copper, then solder the wire on.

    I like to use AWG30 silver-plated wire-wrap wire for such stuff.

    Chuck(G) Today, 05:02 PM Go to last post
    ldkraemer

    OCR process

    Monty,
    I know nothing about that CPU, or that Assembler, I just know a bit about OCR'ing Scans of pages or PDF documents.

    Glad it is working for you so far. Yes, It's easy to strip out the...

    ldkraemer Today, 04:56 PM Go to last post