Image Map Image Map
  • Category Widget (bottom-up)

  • haglebu

    There is no available content written by haglebu
  • Recent Article Comments Widget

  • Recent Forum Posts

    ajacocks

    Many thanks! I could also use a dock, if you...

    Many thanks!

    I could also use a dock, if you have one.

    Have you ever managed to get the machine to boot from PCMCIA?

    Thanks!
    - Alex

    ajacocks Today, 06:49 AM Go to last post
    PeterNC

    Forgot to configure GSPLAY.CFG for a SC-7. The...

    Forgot to configure GSPLAY.CFG for a SC-7. The SC-7 obviously does not have GS nor the corresponding SYSEX messaging.

    PeterNC Today, 06:44 AM Go to last post
    m_thompson

    When I did a CP/M 3 port to a Multibus system a...

    When I did a CP/M 3 port to a Multibus system a few decades ago, the boot EPROM started at address 0 at power on and copied itself to a 4k bank 60k. The EPROM image contained the code to fiddle with...

    m_thompson Today, 06:32 AM Go to last post
    Inu11

    Heya

    Figured I'd say hello!

    Hi, im new! I was brought here by my love of computers - can't say I had much experience with < 90's computers, but I am interested in them all the same. I especially dig...

    Inu11 Today, 06:29 AM Go to last post
    tblake05

    I'll give it a shot. Its more difficult to get...

    I'll give it a shot. Its more difficult to get at the hard drive on the 380 series computers than most.

    It was an unformatted memory card initially when I first tried it. (when it fully booted...

    tblake05 Today, 06:26 AM Go to last post