Vintage Computer Forum - tipc

Category Widget (bottom-up)

tipc

There is no available content written by tipc

Recent Article Comments Widget
Recent Forum Posts

Check the rail guides. Anything hanging on them...

Check the rail guides. Anything hanging on them would be a problem. Also check the wire routing.
I agree about the track 00 sensor, also.
I was told not to grease or oil the pin and groove. It was...
Dwight Elvey Today, 07:38 AM

I remember that directory now. Stack overflow...

I remember that directory now. Stack overflow strikes again. Thanks.
jbdigriz Today, 07:03 AM

Definitely run PETTESTER and see what it displays...

Definitely run PETTESTER and see what it displays for the different combos before changing the hardware.
Nivag Swerdna Today, 07:02 AM

All punches have now been sold.

All punches have now been sold.
zippysticks Today, 06:42 AM

That is typical design for a 3.5" drive. Chances...

That is typical design for a 3.5" drive. Chances are there is some solidified gunk in the groove. I'd clean that grease off with alcohol, make sure the groove is completely clean, and then lightly...
SomeGuy Today, 06:40 AM

All times are GMT -8. The time now is 07:48 AM.

Powered by vBulletin® Version 4.2.5
Copyright © 2021 vBulletin Solutions Inc. All rights reserved.

© 2002-2019 Vintage Computer Federation, all rights reserved