The header, if it has round pins, the pins must have a diameter of 0.45 to 0.5mm. This is the size that suits a round machine pin IC socket, without...
I'm hoping I will be able to get this to run with my AIM-65 with the AH5050 adapter board. Apparently there are two versions of the BIN file for the...
I bought a 5.25" Commodore 1541 disk drive unit. I want to use it in conjunction with my AIM-65 computer. I have also bought an AH5050 board and ROM...
It is almost certain that this capacitor is directly on a power supply line, with little else in series with it, or there would have not been enough...
...If it turned out to be the heater supply from the LOPT causing the banding, I don't think adding an inductor could help as that will just tend to...
Maybe if we could find the data sheet for the CRT, or had a true rms reading meter, we could work out the heater voltage, or a digital scope with an...
Yes, the white glass diodes that are mounted onto the three metal heat sink flags. But likely they are ok, because they are probably for the + power...
The sync tip is fine siting above zero volts, you could increase the pull up resistor value you have added so the level is closer to zero volts, but...
Find latest posts
View Articles
View Blog Entries