View Profile: iz8dwf - Vintage Computer Forum

Tab Content: All; iz8dwf; Friends; Photos

Older Activity
January 21st, 2021, 02:40 AM

iz8dwf replied to a thread Help fixing a semi broken power supply for a Apple II Europlus (230v) in Early Apple (I, ][, ///, etc.)

see if it's the A11040/B, not every label was updated. Frank

see more

5 replies | 164 view(s)
January 18th, 2021, 12:35 AM

iz8dwf replied to a thread Help with fixing Commodore 2040 Dual Floppy drive in Commodore

yes usually you first power up the drive(s), then the PET, at least this is what we were always told to do in the old days. However, the power...

see more

18 replies | 196 view(s)
January 16th, 2021, 01:29 PM

iz8dwf replied to a thread Help fixing a semi broken power supply for a Apple II Europlus (230v) in Early Apple (I, ][, ///, etc.)

http://bitsavers.org/pdf/apple/power_supply/Astec_Power_Supplies_Aug82.pdf There must be a part number on the label of your power supply, telling...

see more

5 replies | 164 view(s)
January 15th, 2021, 01:07 AM

iz8dwf replied to a thread Commodore 1541 drive can't format or read disks in Commodore

well, In the last two years I've repaired at least 10 x 1541 with Newtronics mechanical assembly and I've found only one with failed head. An analog...

see more

9 replies | 202 view(s)
January 12th, 2021, 12:48 PM

iz8dwf replied to a thread Pet 2001 9" Monitor, spot killer. in Commodore

Hi Andy, so basically the spot in your monitor was caused by C4? That's interesting, ceramic capacitors aren't famous for getting leaky. Thanks...

see more

24 replies | 1338 view(s)
January 9th, 2021, 01:05 PM

iz8dwf replied to a thread PET power transformer. in Commodore

Correct, I think he should know this, as he used another PET "PSU" to power-on the board. Frank

see more

6 replies | 270 view(s)
January 9th, 2021, 06:42 AM

iz8dwf replied to a thread 2031 LP drive motor running continuously in Commodore

The 2031LP is basically a 1541 with a different firmware and a different interface, the IEEE488 instead of the serial IEC. The behaviour you're...

see more

6 replies | 246 view(s)
January 9th, 2021, 06:35 AM

iz8dwf replied to a thread PET power transformer. in Commodore

PET motherboard (excluding the original 2001 with static RAM) need: 8-0-8 Vac (center tapped it means), this is rectified on the mainboard to obtain...

see more

6 replies | 270 view(s)
January 2nd, 2021, 08:39 AM

iz8dwf replied to a thread Hazeltine/OSI 1420 blowing fuses in Vintage Computer Hardware

That little thing is a tantalum capacitor. Those are known for making very good short circuits after some years. You should just remove that...

see more

7 replies | 244 view(s)
December 30th, 2020, 01:31 AM

iz8dwf replied to a thread Memory problem with PET 2001 in Commodore

That's wrong. TTL valid High levels start at 2.7V. Often in these old machines, H levels are around 3.5V. 4V is a solid high and perfectly...

see more

52 replies | 1643 view(s)

No More Results

iz8dwf
Senior Member

Mini Statistics

More 2 Friends

retrobecanes

artelse

Recent Visitors

Basic Information

About iz8dwf

Statistics

Total Posts

General Information

2 Friends

artelse

retrobecanes

iz8dwf Senior Member

Mini Statistics

More 2 Friends

retrobecanes

artelse

Recent Visitors

Basic Information

About iz8dwf

Statistics

Total Posts

General Information

2 Friends

artelse

retrobecanes

iz8dwf
Senior Member