No idea about the pins (Al's suggestion sounds good) but the plastic plate could be made with a drilling jig. What sort of tools do you have at hand?...
The first ever ABS print wasn't great. The trim panel bracket was warped on both sides. After reading about possible causes I managed to do a perfect...
OP's requirement specs are pretty vague. From the blurb on that site, someone has already put some thought into it. How much is someone's time worth...
I have been experimenting with "dry" Teflon lubricant. It is wet when you apply it but becomes completely drive after a short while. The advantage is...
Most drives (or their controller) unloaded the head or stopped the spindle after a few seconds of inactivity.
The RX01 appears to unload after every...
Yep that's the book! It was a large quarto size paperback with a blue cover and a green circle on the front. I regret tossing it out some 15 years or...
After reforming the two large capacitors on the RX01 drive I powered it up without any logic connected and found the voltages to be on the high side....
Today I finally pulled apart the dual RX01 from the LAB-8/e rack. After further cleaning it and applying some teflon spray to the lead shaft and the...
Find latest posts
View Articles
View Blog Entries