Image Map Image Map
Tab Content
  • RichCini's Avatar
    Today, 10:21 AM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Yes, good point. I'm going to rebuild my disk images and start over because I needed to change some things anyway. Will update the thread when I've...
    13 replies | 248 view(s)
  • RichCini's Avatar
    Yesterday, 06:51 AM
    I know that CompuPro had an 8085/8088 board that you could switch between them using an I/O port. Also, the S100 Computers "new" boards have several...
    14 replies | 267 view(s)
  • RichCini's Avatar
    February 19th, 2019, 04:59 AM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Thanks. I had previously ran the memory diagnostics when I got the board last week and it passed, so that's good. I did not run the CPU diagnostic,...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 18th, 2019, 01:28 PM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Thanks Jerry. I did a little work this afternoon. I did swap the two boards, but that had no effect. I couldn't readily find the CS Revision on the...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 17th, 2019, 05:38 PM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Ok, so I ran the diagnostics again and logged the session: +++++++++++++++++++++++++++++++++++++ BOOTING UP XXDP-XM EXTENDED MONITOR XXDP-XM...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 15th, 2019, 06:19 PM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Thanks Jerry. I'll dig into this more tomorrow. Rich
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 15th, 2019, 10:58 AM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Right, see that. My system doesn't have a bootstrap board. I would then guess I either need to locate a BDV11 or find the code and load it up from...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 15th, 2019, 10:31 AM
    RichCini replied to a thread Testing a DEQNA (M7504) board in DEC
    Thanks! The second document is the one I have. Page 2-67 is the DEQNA/DELNA diagnostics page but it references a version of the diagnostics that's...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 15th, 2019, 09:28 AM
    All -- I had some time this week, so I swapped boards in my 11/03 to make it into an 11/23 by using KDF11 (M8186-YA) and MSV11 (M8067-KB)...
    13 replies | 248 view(s)
  • RichCini's Avatar
    February 2nd, 2019, 09:09 AM
    RichCini replied to a thread KDF11 board question in DEC
    Thanks Mattis. So if the third chip is the FP chip, what's the fourth socket (second from left with the card edge down) for?
    4 replies | 245 view(s)
  • RichCini's Avatar
    February 2nd, 2019, 07:51 AM
    RichCini started a thread KDF11 board question in DEC
    All -- I pulled an 11/23 CPU card out of my storage in advance of trying to put an 11/23 system together. The card, M8186-YA, should be the...
    4 replies | 245 view(s)
  • RichCini's Avatar
    January 28th, 2019, 09:58 AM
    RichCini replied to a thread Bought a PDP-11/03-L in DEC
    Look for Micronotes #5 ("Q22 Compatible Options") dated 23-Apr-84. That has a lot of info in it related to word-compatibility. I have also have an...
    65 replies | 4196 view(s)
No More Results
About RichCini

Basic Information

About RichCini
Location:
Long Island, NY

Signature


Contact


This Page
http://www.vcfed.org/forum/member.php?902-RichCini&s=d55a8ea259885625ca0a77d444f2b831
Instant Messaging

Send an Instant Message to RichCini Using...

Statistics


Total Posts
Total Posts
355
Posts Per Day
0.07
General Information
Last Activity
Today 10:21 AM
Join Date
August 6th, 2005
Referrals
0
Home Page
http://www.classiccmp.org/cini

1 Friend

  1. Sharkonwheels Sharkonwheels is offline

    Senior Member

    Sharkonwheels
Showing Friends 1 to 1 of 1