Image Map Image Map

Search:

Type: Posts; User: modem7

Page 1 of 20 1 2 3 4

Search: Search took 0.28 seconds.

  1. That 'F300' is known as a 'WD Feature Number.' ...

    That 'F300' is known as a 'WD Feature Number.'

    For example, table 2 within the WDXT-GEN user's guide at [here] reveals that there were (at the time of publication) five different feature numbers...
  2. Replies
    11
    Views
    158

    Which could be because the power supply requires...

    Which could be because the power supply requires an adequate load in order to operate.


    So, at this point, power supply still not proven as good or bad (i.e. could be an overloaded good power...
  3. The revision number of BIOS ROM's that Western...

    The revision number of BIOS ROM's that Western Digital use on their XT-class and AT-class hard disk controllers, is a long number, like 62-000042-11 and 62-000215-060 and 62-000089-030. For example,...
  4. Replies
    17
    Views
    298

    But maybe all six were repaired under warranty...

    But maybe all six were repaired under warranty and/or repaired subsequently.
  5. Replies
    15
    Views
    361

    I modified the diagram at [here...

    I modified the diagram at [here].
  6. Setting the XT/AT jumper to 'AT' does not turn...

    Setting the XT/AT jumper to 'AT' does not turn the controller into an AT-class one. We know that because it is not possible for an 8-bit card to generate interrupt 14.

    The information at [here]...
  7. Member SomeGuy made a copy of the BIOS ROM on his...

    Member SomeGuy made a copy of the BIOS ROM on his WD1002A-WX1.
    That copy is at [here].
    It is an 'F300' version, which means that it has 'dynamic' functionality - see [here].

    If you are unable to...
  8. I browsed through my records. There is an...

    I browsed through my records.

    There is an email trail from a member here.
    He had an Olivetti M24, and the M24 contained a DTC 5150BX4 that was missing its BIOS ROM chip.
    After research, he later...
  9. Because you set a type number into the AT's...

    Because you set a type number into the AT's BIOS/CMOS SETUP, the POST went looking for an AT-class MFM controller and drive.

    XT-class MFM controllers and AT-class MFM controllers are different....
  10. To add 'Australia' (or 'Land of the kangaroos',...

    To add 'Australia' (or 'Land of the kangaroos', or 'Land of koala burgers', etc.) to your profile, the navigation is: [My Profile][About Me][Location].
  11. Replies
    11
    Views
    158

    Coincidental, or could it be that the "new CR2032...

    Coincidental, or could it be that the "new CR2032 Battery job" is somehow overloading the power supply.

    How did you prove that the power supply is the problem cause?


    I did too. Is photo #2...
  12. Refer to the diagram at [here...

    Refer to the diagram at [here]. Frequency changes shown in red.

    - 8288 needs a faster rating ?
    - Any fitted NPU needs a faster rating ?
    - Change to PCLK ; impact to things relying on the 8253...
  13. I found a photo online of the rear of an Amstrad...

    I found a photo online of the rear of an Amstrad PC5086.
    So a 9-pin RS232 port, which appears to be part of the motherboard.


    The TxD pin (pin 3 on the 9-pin connector) normally sits at the...
  14. Replies
    39
    Views
    1,259

    Using the camera on my mobile phone, the LED in...

    Using the camera on my mobile phone, the LED in my TV's remote shows quite well in normal room light, and up to 45 degrees off the center-line of the LED.

    But another remote of mine, one for a...
  15. Try the diagnostic procedure at [here...

    Try the diagnostic procedure at [here]. No keyboard required.
  16. I did some experiments a while back. The results...

    I did some experiments a while back. The results are at [here].
  17. It does.

    It does.
  18. Entering "key off" removed the black blocks, and...

    Entering "key off" removed the black blocks, and entering "color 4" showed a red block.
    Photo at [here].
  19. Suggested by Eudimorphodon at post #7 I will...

    Suggested by Eudimorphodon at post #7


    I will get onto that then report back.
  20. Supporting that: I removed the hard disk...

    Supporting that:

    I removed the hard disk controller from my IBM 5160 so that the 5160 would boot to Cassette BASIC.
    On the 5160's IBM CGA card, I removed the character ROM from its socket.
    I...
  21. Welcome to these forums. What pins are...

    Welcome to these forums.


    What pins are connected to what?


    What do you mean by "on" ?

    RS232 output signals have two levels; a positive voltage or a negative voltage. There is always a...
  22. Hopefully it will work. On the 5150...

    Hopefully it will work.


    On the 5150 motherboard, the two video switches are to be both set to ON.


    If the layout of your card matches the one at [here], then the jumper at position SW4 needs...
  23. Replies
    39
    Views
    1,259

    I did not notice the gap. How embarrassing. Hold...

    I did not notice the gap. How embarrassing. Hold a second whilst I look an excuse. Found it. My LCD monitor has a 'nonlinear horizontal deflection' problem, resulting in me not seeing the gap.

    I...
  24. Replies
    40
    Views
    1,122

    I put a write-up at [here...

    I put a write-up at [here].
  25. Replies
    39
    Views
    1,259

    5-band, that colour wise, looks like...

    5-band, that colour wise, looks like |orange|black|brown|red|brown|

    Per the 'Resistor Color Code Table' at [here], 30.1 kΩ of 1% tolerance
    Example at [here].

    Looking at your multimeter photo,...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4