Image Map Image Map

Search:

Type: Posts; User: T-R-A

Page 1 of 13 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    89

    Yep, common practice. In fact, we have an...

    Yep, common practice. In fact, we have an assembly at work that I work on that normally comes in with 2000F 35v electrolytic filter caps on the output of the 12v power supply. Another assembly we...
  2. Replies
    5
    Views
    108

    And there's no reason you couldn't replace...

    And there's no reason you couldn't replace radials with axials (or vice-versa) either, as long as the leads are long enough and there's not any issue with clearance.
  3. Replies
    5
    Views
    108

    Most designs are largely influenced based on...

    Most designs are largely influenced based on cost. At that time, the likely requirements were cheaper with an radial capacitor than a axial one. The next highest priority is usually real-estate...
  4. Replies
    5
    Views
    108

    Shouldn't be a problem. Make sure you observe...

    Shouldn't be a problem. Make sure you observe correct polarity when replacing. As long as a capacitors stated voltage is equal or greater (up to a point), then it theoretically should work.
  5. Replies
    4
    Views
    123

    Correct me if I'm wrong, but is that...

    Correct me if I'm wrong, but is that furthest-right capacitor in your 2nd pic (C110?) installed backwards? Looks like the stripe is going to the (+) side of the silk screen on the motherboard...just...
  6. Yep, same here. GSETUP is a great utility on...

    Yep, same here. GSETUP is a great utility on older 286/386's. FYI, available here:

    https://www.elhvb.com/webhq/download/index.htm
  7. Sounds like the pot needs some Deoxit. Until...

    Sounds like the pot needs some Deoxit. Until then, you may have more vertical-hold issues....
  8. Replies
    26
    Views
    1,013

    Any standard diode (non-zener) should suffice. A...

    Any standard diode (non-zener) should suffice. A good (cheap) example is a 1N4148
  9. Replies
    5
    Views
    354

    As with any machine, it wouldn't hurt to (maybe...

    As with any machine, it wouldn't hurt to (maybe annually) check the inside for dust or obvious visual problems. Maybe run a "drive maintenance" program to see if everything is ok. Otherwise I'd...
  10. Replies
    1
    Views
    203

    Most likely the former. Few repair facilities...

    Most likely the former. Few repair facilities used stamps...most likely they were using some sort of sticker.
  11. Replies
    15
    Views
    750

    Agree totally. I've replaced lots of caps on the...

    Agree totally. I've replaced lots of caps on the same voltage line without replacing any of the others. 5+ years on a lot of things without any problems. Unless there's a known bad batch of them,...
  12. Replies
    19
    Views
    856

    So TAB, arrow-keys, or nothing works? Are you...

    So TAB, arrow-keys, or nothing works? Are you certain the keyboard is OK?
  13. Replies
    19
    Views
    856

    Thought you said there's a "user-defined" type...

    Thought you said there's a "user-defined" type 49? That's where you need to input the geometry.
  14. Replies
    19
    Views
    856

    https://stason.org/TULARC/pc/hard-drives-hdd/teac/...

    https://stason.org/TULARC/pc/hard-drives-hdd/teac/SD-340H-30-42MB-3-5-SL-IDE-AT.html
  15. Replies
    21
    Views
    1,134

    I'd go with the Tandy (Kyocera) TRS-80 Model 100....

    I'd go with the Tandy (Kyocera) TRS-80 Model 100. More "Laptop-like" than "Laptop", it showed that portable computing was indeed possible...
  16. Replies
    25
    Views
    1,190

    Not only would the caps blow, but everything on...

    Not only would the caps blow, but everything on that rail would as well....
  17. As modem7 mentions, it could be a RTC-module and...

    As modem7 mentions, it could be a RTC-module and not a "physical" battery. The symptoms shown (Invalid Config, Disk Drive 0/1 errors) indicates that the CMOS/BIOS has lost parameters of what the...
  18. Good point. If it's not got any kind of a...

    Good point. If it's not got any kind of a charge, it's just sitting there being a potential hazard.
  19. Looks like that's it, according to this: ...

    Looks like that's it, according to this:

    http://www.kahlon.com/itemdetailpg.asp?itemid=355912

    Odd that they'd offer it for a Contura 3/25 (386-based machine) since that pre-dated Win95 (and...
  20. Sorry, didn't catch that...and good point.

    Sorry, didn't catch that...and good point.
  21. Any card added to the system will increase the...

    Any card added to the system will increase the load (i.e.-decrease the resistance) on the power supply. With the power supply unplugged from the motherboard, and measuring (with an ohmmeter) across...
  22. Replies
    4
    Views
    409

    Quite possibly a flyback transformer. Not a fun...

    Quite possibly a flyback transformer. Not a fun thing to fix.
  23. We all would. But board schematics are a rare...

    We all would. But board schematics are a rare thing indeed. Probably only IBM certified repair techs would have them (and I'm doubtful even they would). Stuff like that is usually on a company's...
  24. If you're going larger than 540MB, then you might...

    If you're going larger than 540MB, then you might as well go with a drive overlay. Realize there's significant limits on drive/RAM sizes for such OS's as DOS/Win3.x & Win9x. And yes, you can...
  25. From the photo, you've got a bad CMOS battery. ...

    From the photo, you've got a bad CMOS battery. Fortunately, AT and PS/2 type keyboards are pretty much universal. The only ones I've had problems with were Compaq's and an occasional Dell. If...
Results 1 to 25 of 314
Page 1 of 13 1 2 3 4