Image Map Image Map

Search:

Type: Posts; User: riwide

Search: Search took 0.01 seconds.

  1. I am now successfully working at 115200 baud with...

    I am now successfully working at 115200 baud with rom-mjs multicomp. My problems of serial corruption were caused by an FTDI clone (didn't intend it to be a clone when I purchased from Amazon),...
  2. Thank you, I've just tried that and the baud rate...

    Thank you, I've just tried that and the baud rate is working at the higher speed, though doing [return key] multiple times at cp/m command prompt is not just giving me the command prompt, I am...
  3. Multicomp z80 rom-mjs - changing baud rate?

    Does anyone know how to change the default baud rate from 9600 to 115200 on cycloneiic-z80 running cp/m 2 with rom-mjs?
    I don't know where these settings are defined, perhaps the multicomp build? or...
  4. Replies
    7
    Views
    503

    I am convinced that the mc-2g-1024 build is...

    I am convinced that the mc-2g-1024 build is broken. Superficially it appears to run cpm2, cpm3 dos+ etc but I cannot run debuggers properly. The cycloneiiz80 build with rom-mjs runs all my debuggers...
  5. Replies
    7
    Views
    503

    Thanks for the suggestion of using DBGINST alter...

    Thanks for the suggestion of using DBGINST alter the restart vector. I tried it, setting RST 6 rather than RST 7 and it did not improve the problem, it even seems worse.
  6. Replies
    7
    Views
    503

    Thank you for the suggestion. Looking at the code...

    Thank you for the suggestion. Looking at the code it seems to me that the cbios is setting up a RST 7 responder to act on a hw initiated timer interrupt, so changing to setup a responder on RST 6...
  7. Replies
    7
    Views
    503

    Strange - the web site works for me today and a...

    Strange - the web site works for me today and a few days ago before I submitted to this thread, however it did fail for me about a week ago when I wanted to get debugz from the official source rather...
  8. Replies
    7
    Views
    503

    Problem running DebugZ on Multicomp CP/M

    I have built a standard Cyclone II c version of Multicomp and having good fun with it (mostly using mc-2g-1024 build) and have identified one application which is incompatible but runs on other CP/M...
Results 1 to 8 of 8