Image Map Image Map

Search:

Type: Posts; User: Malc

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    28
    Views
    369

    Yes, I've seen what it can do to human flesh, Not...

    Yes, I've seen what it can do to human flesh, Not good.
  2. Thread: Help required

    by Malc
    Replies
    7
    Views
    81

    In the UK, I recall the name,...

    In the UK, I recall the name, https://www.theregister.co.uk/2001/09/28/tempo_in_adminstration/
  3. Replies
    11
    Views
    170

    I tend to Re-work IDE / Floppy cable's to the...

    I tend to Re-work IDE / Floppy cable's to the length i need, I usually find with Pre-made cables they are either way too long / too short or the right length but the secondary conector's are in the...
  4. Replies
    1,071
    Views
    168,701

    Yes because it does not always work due to...

    Yes because it does not always work due to different drive geometries. You could try it but i would suggest you use the latest revision of the XUB r602 http://www.xtideuniversalbios.org/binaries/

    ...
  5. Replies
    1,071
    Views
    168,701

    I assume you mean the Lo-Tech ISA - CF rev3 or do...

    I assume you mean the Lo-Tech ISA - CF rev3 or do you mean the GW XTIDE Rev 3 ?, What version of the XUB are you using, Did you configure it properly using XTIDECFG.com first before flashing to...
  6. I've never seen the source around though i...

    I've never seen the source around though i wouldn't be surprised if it was never released.
  7. For some reason i think that was the one i could...

    For some reason i think that was the one i could not get to load high when i tried a long time ago, But it doesn't bother me i just let them load low, Do what i got to do and then unload them.
  8. Yep me too, works very well, The panasonic...

    Yep me too, works very well, The panasonic drivers are not so good with UHCI, But the Iomega drivers work fine with UHCI but use more memory.
  9. Replies
    5
    Views
    196

    Apart from keeping it clean and maybe running a...

    Apart from keeping it clean and maybe running a floppy drive cleaning disk in the drives now and again depending on how much use the floppy drives get, I'd leave it be, "If it aint broke don't fix...
  10. Replies
    544
    Views
    92,843

    I posted XUB r601 with Boot Menu and Very late...

    I posted XUB r601 with Boot Menu and Very late init a while back, See post #512 in this thread, Might be worth a try.
  11. Replies
    18
    Views
    624

    Good thinking, I've seen those hole patterns too...

    Good thinking, I've seen those hole patterns too on other cards but never put any thought into them other than maybe test points, I probably have some cards stashed away with the same.
  12. I don't have one of those cards but usually with...

    I don't have one of those cards but usually with the 4 pin LED connector just use pins 1 and 2 OR pins 3 and 4 if your led has a 2 pin connector, Different LED's operate at different voltages, Use a...
  13. Replies
    15
    Views
    434

    I would just replace the one that shorted,...

    I would just replace the one that shorted, Chances are the rest will be fine.
  14. Replies
    1,071
    Views
    168,701

    My first thought is an incompatibility between...

    My first thought is an incompatibility between the Z-171 bios and the XUB, What boot options does your Z-171 have in the system setup ?, I downloaded a manual for the Z-170 and the boot options for...
  15. Replies
    1,071
    Views
    168,701

    Never tried a microdrive, I looked at them a long...

    Never tried a microdrive, I looked at them a long time ago but thought they were expensive then, My preference to CF now is SD cards, The adapters cost a little more but are far superior to the dumb...
  16. Replies
    1,071
    Views
    168,701

    Yes sometimes a partial wipe is not sufficient...

    Yes sometimes a partial wipe is not sufficient and a complete wipe of the CF is required, There is / was free DOS utilities around the net that could zero out CF but it was a long time ago and the...
  17. Replies
    1,071
    Views
    168,701

    Yes i agree, I use WipeDisk and it works for me.

    Yes i agree, I use WipeDisk and it works for me.
  18. That's correct XTIDECFG.COM does not support the...

    That's correct XTIDECFG.COM does not support the SST EEPROM, It sounds like you might be using a version of XTIDECFG that's not compatible with the bios you are trying to configure, For example, If...
  19. Replies
    18
    Views
    738

    Oooh that's a lot of floppies, Who's got the job...

    Oooh that's a lot of floppies, Who's got the job of testing them hehe.
  20. Thread: Radio Shack

    by Malc
    Replies
    49
    Views
    1,227

    Hehe i remember the "Greasy spoon" type chip...

    Hehe i remember the "Greasy spoon" type chip shops well, Cod and chips swimming in grease.
  21. Thread: Radio Shack

    by Malc
    Replies
    49
    Views
    1,227

    I do like a good curry, Chicken or Beef my...

    I do like a good curry, Chicken or Beef my favorite, I could eat them everyday.
  22. Unfortunately when they "Explode" they can...

    Unfortunately when they "Explode" they can sometimes take out something else on the card, I have 2 IBM CGA cards here, Both worked perfectly until one day a tant C8 exploded, I replaced the tants but...
  23. Replies
    35
    Views
    1,898

    I would look at upgrading to v06, The files...

    I would look at upgrading to v06, The files should be in the files section of the Data I/O group, You will need 7 2732 eproms, BUT first what is the part number of the motherboard, Remove the...
  24. Replies
    1,071
    Views
    168,701

    No you're not blind, There is no link to the...

    No you're not blind, There is no link to the binaries on the main site, It's been commented on many times before but nothing been done about it.
  25. Replies
    1,071
    Views
    168,701

    there has been lots,...

    there has been lots, http://www.xtideuniversalbios.org/binaries/ r602 is the latest
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4