Image Map Image Map

Search:

Type: Posts; User: NeXT

Page 1 of 20 1 2 3 4

Search: Search took 0.14 seconds.

  1. Replies
    10
    Views
    128

    This however, brings up a good point. ALL of...

    This however, brings up a good point.

    ALL of the AV models, plus the 800 of the Quadra series require recapping, so keep that in mind. The 700, 900 and 950 are tantalum and metal film based and...
  2. Replies
    10
    Views
    128

    If you can get a Quadra, it's worth it. I've...

    If you can get a Quadra, it's worth it. I've found them to be excellent 7.6 machines with minimal upgrades and will run just about any 68K software you throw at them, plus onboard networking!
    I've...
  3. Transformers don't normally have a shelf life, so...

    Transformers don't normally have a shelf life, so if they are just seemingly going up in flames for no reason they are being overloaded or overdriven.
  4. Replies
    13
    Views
    303

    That was part of the fun in Deus Ex. You aren't...

    That was part of the fun in Deus Ex. You aren't just shooting your way to the end of the level like it's DOOM or Half-Life. There's this thing called a backstory which makes a plot setting and if you...
  5. Replies
    2
    Views
    136

    You had that listed for not even half an hour....

    You had that listed for not even half an hour.
    Holy crap that sold fast!
  6. Replies
    13
    Views
    303

    Yes the story ramps up after two or three levels...

    Yes the story ramps up after two or three levels when you start to suspect something is going on.
  7. Replies
    8
    Views
    332

    It sold for $14400cad with at least one bid...

    It sold for $14400cad with at least one bid retraction. I do believe that is a new record.
  8. Replies
    8
    Views
    332

    I can only assume it's an AS-IS loophole. I...

    I can only assume it's an AS-IS loophole.
    I mean, you COULD list it working with the original box, but it's an Amiga with a lot of aftermarket mods. The fact it's working at all is a miracle.

    For...
  9. Replies
    4
    Views
    162

    At this point I've started passing on plasmas...

    At this point I've started passing on plasmas that were not the commercial grade units. I've found that while heavier and boxier their build quality was often better.

    Once you got burn-in though,...
  10. Replies
    3
    Views
    4,138

    This thread is over ten years old however someone...

    This thread is over ten years old however someone brought it to my attention recently that I never really came back to tell if it worked or not.
    The answer is yes. The machine works fine with them....
  11. Replies
    2
    Views
    118

    Is this a official Apple serial cable or a third...

    Is this a official Apple serial cable or a third party? All I can think of is some of the knockoff cables were not wired the same.
  12. Replies
    12
    Views
    354

    1: As mentioned, the motor speed is critical. 2:...

    1: As mentioned, the motor speed is critical.
    2: Most people just put a piece of tube over it. That should last a lot longer than heat shrink.
    3: That will work fine
    4: That will work fine as well...
  13. I think Chuck is implying he doesn't have the...

    I think Chuck is implying he doesn't have the ability to do that right now. ;)
  14. Hey, Snuci, you able to chime in here? I know...

    Hey, Snuci, you able to chime in here?
    I know there was a thread a few years back where you were asking the same about disks but the link you posted at the bottom doesn't work anymore.
    ...
  15. Replies
    14
    Views
    310

    300 ohms across VCC and ground seems oddly low...

    300 ohms across VCC and ground seems oddly low for most IC's unless there's something going inside I don't fully understand.

    eBay is telling me your options start at around $5 per chip so I would...
  16. Replies
    6
    Views
    2,259

    Oh that's excellent! I still have the assembly...

    Oh that's excellent!

    I still have the assembly but set it aside because I got hung up trying to figure out if the punch was RPM reliant on punch timing. This seems to go over everything.

    The...
  17. Replies
    14
    Views
    526

    I meant custom as in yes it's still a clone that...

    I meant custom as in yes it's still a clone that was mass produced, but by no means is it a generic XT clone or cheap plastic Apple II enclosure. Perhaps "unique" was a better word. :P
  18. Replies
    14
    Views
    526

    That is indeed a clone Apple II in a custom...

    That is indeed a clone Apple II in a custom PC-style enclosure. That's a custom tooled case. That's amazing and someone got a damn good deal on it.
  19. Replies
    17
    Views
    688

    I mean.....probably? Everything I've read so far...

    I mean.....probably?
    Everything I've read so far is that the SE/30 PDS slot can be made to work with the 040 upgrade cards from Daystar, so I would take a hazardous guess and assume the Turbo 601...
  20. I have seen SEM dyes get used in places like car...

    I have seen SEM dyes get used in places like car interiors but computers is a new one. I have tried more generic dyes like RIT on plastic before on drive bezels and faceplates with lackluster...
  21. I gotta hand it to the unintentional security of...

    I gotta hand it to the unintentional security of these older 2-cable drives and controllers. The amount of trouble a drive separated from its controller can cause when trying to read the data back is...
  22. Replies
    24
    Views
    1,887

    I got a 520ST (the external floppy model) in late...

    I got a 520ST (the external floppy model) in late 2010 and by 2012 I had upgraded to a 1040STF with a Megafile 30, color monitor and a Unitor-N.
  23. Replies
    19
    Views
    1,018

    Thanks Orange. It looks like it was a mix of...

    Thanks Orange. It looks like it was a mix of NTLDR and later NTDETECT by mistake.
    Twofold problem. As it turns out, you cannot properly fix bootloader problems on Server 2003 Enterprise with the XP...
  24. Replies
    19
    Views
    1,018

    Well both FIXMBR and FIXBOOT ran successfully and...

    Well both FIXMBR and FIXBOOT ran successfully and the disk is still readable from within the repair console and in a different machine but it's still giving me the NTLDR IS MISSING error at boot so...
  25. No they aren't. The battery gives them a shelf...

    No they aren't. The battery gives them a shelf life regardless if they are used or not.


    You have to treat it as a monochrome display with a color video input. Nothing really takes advantage of...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4