Search:

I have several from a run of five and will be glad to send you one. Let me know address (offline?).

Just to be sure, you are looking for Roland’s board that is about 1/3 height of standard Omnibus...

This is a note presenting my experience in building, testing and using Roland Huisman’s RX8E 74xx clone controller board. My intent is to show the steps I took, as encouragement for others interested...

As a follow-up to my note from yesterday, I run Kyle's SerialDisk with a M8650 modified as per the link in anders_bzn's note to achieve 115200 baud and disk.cfg set for 2 stop bits. Addresses set to...

I run my “dumb” terminal at 9600 baud using Putty. I also have used TerraTerm (sp?) and Simple Term successfully. I’ll check bits, stop bits, parity, etc. when I get home tomorrow. I have not had...

Thanks for the great write-up and photos in your link. I followed your directions closely [and carefully] and have my M8650 up and running in my PDP8/E at 115200 baud.

SerialDisk is certainly...

This note presents my experience in building Roland Huisman’s M847 extended edition Bootloader. My intent is to encourage others interested in the board but maybe hesitant based on skill level to...

I too would like one or two boards to complement my PDP8/E. I can handle the hardware side, but the software and flashing part would be more challenging for me. Using a BC01V is good for me...

Matt