Image Map Image Map
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Cromemco 8K Bytesaver transformer question

  1. #11
    Join Date
    Jan 2007
    Location
    Pacific Northwest, USA
    Posts
    27,360
    Blog Entries
    20

    Default

    Um, isn't that what fuses are for?

  2. #12

    Default

    Quote Originally Posted by Dwight Elvey View Post
    Looking at the schematic, I'd say 1 & 4 are the feedback. 3 is the bottom of the output coil, 2 is the center ( may be offset towards 3 ) and 5 is the top of the coil.
    3 and 4 could be swapped but it makes little difference.
    Dwight
    Giving some more thought, the feedback winding might be from 1 to 2. The power winding from 2 to 3 and the output from 4 to 5.
    That sounds better. The additional winding 4 to 5 would be to keep the flyback voltage low, on the transistor. The feedback is capacitor
    isolated so pin 2 is essentially ground through bypass caps.
    Dwight

  3. Default

    Quote Originally Posted by Chuck(G) View Post
    Um, isn't that what fuses are for?
    You know the saying "A Transistor Protected By A Fast Acting Fuse Will Protect The Fuse By Blowing First"? That goes double for the TI switcher IC on that board. My solution prevented further disruptions to EPROM production and located the defective component, so I'll call it a success.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •