Chuck(G)
25k Member
Oh, this 6300 box is maddening. At any rate, it looks as if the original owner disabled the onboard video card; now I'm trying to figure out how to re-enable it.
I've got the P8 revision video adapter.
Motherboard SW1, 5 and 6 are set off (monochrome).
The jumper block up at the top of the board next to the crystal oscillator is set to 2-3 and 5-6.
Jumper W1 is set to 2-3
Jumper W2 is set to 1-2
Jumper W3 is set to 1-2
And there's a wired header block at 5H.
The upshot is that the board remains disabled; the video RAM isn't even mapped in.
Can anyone compare what they have with this and tell me how theirs is set up. I can't seem to find a schematic for the P8 board (only the P2) which is hindering me somewhat.
I've got the P8 revision video adapter.
Motherboard SW1, 5 and 6 are set off (monochrome).
The jumper block up at the top of the board next to the crystal oscillator is set to 2-3 and 5-6.
Jumper W1 is set to 2-3
Jumper W2 is set to 1-2
Jumper W3 is set to 1-2
And there's a wired header block at 5H.
The upshot is that the board remains disabled; the video RAM isn't even mapped in.
Can anyone compare what they have with this and tell me how theirs is set up. I can't seem to find a schematic for the P8 board (only the P2) which is hindering me somewhat.