smp
Veteran Member
Hello all,
I know this has probably been discussed before, so a pointer to the proper discussion would be appreciated.
I recently set up an HP Vectra 510 with MS-DOS 5 and both a 360K 5.25 inch floppy drive and a 1.2 MB 3.5 inch floppy disk drive. I use this machine to read and write floppy disks for CP/M and my HP-86B.
I would like to be able to read the older 8 inch floppy disks to retrieve CP/M programs, as well.
Can anyone tell me (or point me to) information about how to go about interfacing an 8 inch floppy disk drive to an IBM PC clone?
Thanks very much, in advance, for your patience and attention.
smp
I know this has probably been discussed before, so a pointer to the proper discussion would be appreciated.
I recently set up an HP Vectra 510 with MS-DOS 5 and both a 360K 5.25 inch floppy drive and a 1.2 MB 3.5 inch floppy disk drive. I use this machine to read and write floppy disks for CP/M and my HP-86B.
I would like to be able to read the older 8 inch floppy disks to retrieve CP/M programs, as well.
Can anyone tell me (or point me to) information about how to go about interfacing an 8 inch floppy disk drive to an IBM PC clone?
Thanks very much, in advance, for your patience and attention.
smp